What is the proximity effect, and how do you use it to sound warmer?
Why a directional mic can add 6 to 10 dB of bass when you work it close, how to find your own warm-but-clear distance with a ruler and four takes, and what to do when the low end turns to mud.
Late on a stream, the chat slows down and you lean in to say something quietly. Your voice drops into a low, velvet register that sounds nothing like the person who was reading donations ten minutes ago. Then you sit back to check the second monitor, and the same voice comes out thin and a little boxy. You did not touch a single setting. You moved maybe 15 centimeters, about six inches.
That shift has a name: the proximity effect. It is the cheapest tone control you own, it comes built into every directional mic, and it is also the reason some people sound like a muffled late-night DJ on every call. This page explains what it is, why it happens, how to dose it on purpose, and when to rein it in.
If what you are really after is the full announcer sound, with compression and EQ on top of distance, the radio voice guide is the better page for you. Stay here if you want to understand the one lever that costs nothing: how far your mouth is from the mic.
What is the proximity effect
The proximity effect is the rise in bass you get when you move a directional microphone closer to the source. Neumann's explanation puts it in one line: the closer you get, the bigger the bass boost. Back away and the low end drains out again.
Three things about it matter more than the definition:
- It only happens on directional mics. Cardioid, supercardioid and figure-8 mics show it. A true omnidirectional mic does not.
- It only touches the low end. Neumann notes it is most noticeable on sound with a lot of content below 200 Hz. Your consonants and the "s" sounds barely change; the chest of your voice does.
- The numbers are large. Shure's SM58 user guide says cardioid mics progressively boost bass by 6 to 10 dB below 100 Hz when the mic is about 6 mm from the source. Ten decibels is roughly what a heavy-handed EQ boost looks like, and you got it for free by leaning in.
Shure's guide goes a step further and says the effect "can be used to create a warmer, more powerful sound." Neumann calls it a friend and an enemy at the same time. Both are right, and the rest of this page is about keeping it on the friendly side.
Why it happens: two kinds of microphone
There are two basic ways a mic capsule can hear sound, and Sound On Sound's long piece on the effect lays them out clearly.
A pressure capsule has its diaphragm open to the air on one side only. It works like a very fast barometer, it hears from every direction equally, and it is omnidirectional by nature. It has no proximity effect.
A pressure-gradient capsule has its diaphragm open on both sides. It moves when the pressure on the front differs from the pressure on the back. Sound that hits the front has to travel a little farther, about 1 cm in the SOS example, to wrap around to the back, so the two sides see the wave at slightly different moments. That timing difference is what drives the diaphragm. On its own this design gives a figure-8 pattern.
Now add the inverse-square law: sound from a small source loses 6 dB every time the distance doubles. When the mic is a meter away, that extra centimeter to the back of the diaphragm changes nothing. When your mouth is 2 cm away, the back of the diaphragm is half again as far from the source as the front, so it gets a clearly quieter copy of the wave. That level difference adds a second push on the diaphragm.
Why only the bass? Low frequencies have long wavelengths. A 50 Hz wave is almost 7 m long, so across a 1 cm gap it creates a tiny timing difference and a tiny push. The level difference from being close is small too, but compared to that weak low-frequency push it is huge. At 5 kHz the timing push is already strong and the extra level difference hardly registers. So the closer you get, the more the lows get lifted relative to the highs.
A cardioid capsule is a 50:50 blend of pressure and pressure-gradient behavior, according to Neumann. The pressure half ignores distance, so SOS calculates that a cardioid has half the proximity effect of a figure-8. On their theoretical chart, an ideal figure-8 at 5 cm is boosted by more than 20 dB at 100 Hz.
How strong it is on each pickup pattern
| Pickup pattern | Proximity effect | Examples you may own |
|---|---|---|
| Omnidirectional | None | Hollyland Lark M2 clip-on (omni per Hollyland), a Yeti switched to omni |
| Cardioid | Strong, about half of figure-8 | Shure SM58, Shure SM7B, a Yeti in cardioid mode |
| Figure-8 (bidirectional) | Strongest | Ribbon mics, a Yeti switched to bidirectional |
| Variable-D cardioid | Designed to stay small | Electro-Voice RE20 |
Two rows deserve a comment.
Multi-pattern mics let you choose. Logitech's spec sheet for the Yeti lists cardioid, bidirectional, omnidirectional and stereo modes. Neumann says its own research shows that multi-pattern mics behave like fixed-pattern ones here, so the pattern switch is also a proximity switch. Neumann even suggests figure-8 mode for more low end on a thin voice. On a call, though, figure-8 also hears everything behind the mic as loudly as you, so treat that as a recording trick, not a meeting setting.
The RE20 is the opposite design goal. Electro-Voice's product page says its Variable-D design gives "no bass-heavy proximity bump, no thin edge when you back away." Electro-Voice pitches it as the mic that "defined the sound of radio for generations," and steady low end is exactly what a host who shifts around in the chair needs.
How to use proximity effect to sound warmer
Distance is the dial. Shure's SM58 guide includes a placement table that works as a starting map for any cardioid speech mic:
| Mouth to mic | What Shure says you get |
|---|---|
| Under 15 cm, up to touching the grille | Full sound, emphasized bass, maximum isolation from other sources |
| 15 to 60 cm, just above nose height | Natural sound, reduced bass |
| 20 to 60 cm, slightly off to one side | Natural sound, reduced bass, minimal "s" sounds |
| 90 cm to 1.8 m | Thinner, distant sound, noticeable ambient noise |
The SM7B guide narrows this for a broadcast-style dynamic: speak 2.5 to 15 cm away, move closer for warmer bass, move away for less. A sensible place to start inside that range is 5 to 10 cm. A higher or lighter voice usually takes more closeness before it gets heavy, because, as Neumann points out, there is less of it below 200 Hz for the effect to lift.
A ten-minute distance test
Guessing does not work here, because your own head hears your voice through bone and makes it sound fuller than the mic does. Record instead.
- Put a ruler or tape measure next to the mic. Mark 3, 6, 10 and 20 cm.
- Pick one sentence with low and high sounds in it, something like "Big boxes of soft socks sit by the door."
- Record it once at each mark, speaking at the same loudness. Any recorder works; the guide on recording audio on a Mac covers the built-in options.
- Before you compare, match the levels. Each time you halve the distance the voice gets about 6 dB louder, and louder always sounds "better" for the first few seconds. Turn the quieter takes up in the player, or nudge the gain, so you are judging tone and not volume.
- Listen on headphones. Pick the closest take where words still sound clear and the "b" and "d" sounds do not thump.
That take is your distance. Mark it: a strip of tape on the boom arm, or a pop filter set at that spot so your face cannot drift closer. The pop filter guide explains why the filter doubles as a distance stop.
A free second dial: angle
Sound On Sound points out that the proximity effect lives in the figure-8 part of a directional mic's pickup. If you speak slightly across the mic instead of straight into it, you get less bass lift at the same distance. That is useful when you want the isolation of working close but your voice is getting heavy: keep the distance, turn the mic a little off your mouth line. The SM58 table hints at the same thing with its off-to-the-side position and fewer "s" sounds.
A hidden bonus: less room
Working close does two jobs at once. Your voice gets louder at the capsule while the room, the fan and the street stay just as loud, so the balance tips toward you. SOS also notes that a directional mic tuned to sound flat when close will turn down low-frequency spill from distant sources, because only the nearby source gets the bass lift. That is part of why a close dynamic mic picks up less of an untreated room. The trade-offs of that setup are covered in more depth in whether a dynamic mic is really better for podcasting.
When the proximity effect works against you
Warm and muddy live next door to each other. Neumann warns that too much proximity effect can compromise speech intelligibility, and on calls intelligibility wins every time.
Mud on calls. On a call your voice also has to survive noise suppression, the connection and the other person's laptop speakers, and a heavy low end eats into the clarity that is left. If colleagues ask you to repeat yourself while you sound great to yourself, the bass is a suspect. The page on a muffled mic that sounds far away walks through the other usual causes.
Tone that moves with your head. A cardioid at 4 cm sounds like a different mic at 12 cm. On a stream or a long podcast you lean, turn and sit back, and every move rewrites your EQ. A steady 8 cm usually serves the listener better than a wandering 3 to 12, even though 3 cm is warmer at its best moment. This is the problem the RE20's Variable-D design was built to solve.
Plosives and breath. Close range is also where "p" and "b" bursts hit the diaphragm hardest, and the proximity effect boosts exactly the low thump those bursts carry. That is why Shure includes the larger A7WS windscreen with the SM7B for close-talk use.
Rumble. Air conditioning, traffic and desk knocks live in the low end too. Shure suggests the SM7B's bass rolloff switch partly for HVAC and traffic hum.
How to tame it, in order of cost
- Back off 2 to 4 cm. Free, instant, and often enough.
- Angle the mic so you speak slightly across it.
- Use the bass rolloff switch if your mic has one. On the SM7B it is the left switch, pushed down, and Shure says you can flip it while the mic is in use.
- Add a high-pass or low-shelf EQ in your recording or streaming software. The guide to OBS mic filters covers the order for streams.
- Pick a mic built for it if you move a lot: the Variable-D route, or simply a mic with a bass roll-off already tuned in. Shure says the SM58's response includes a bass roll-off "to control proximity effect."
What if your mic has no proximity effect at all
Plenty of people never get to use this trick. A clip-on wireless like the Lark M2 is omnidirectional, so moving it closer adds level but no warmth. The MacBook's own mic usually sits half a meter or so from your mouth, too far away for the effect to add much. AirPods and most headsets put the mic where you cannot change the distance at all.
With those mics, warmth has to come from processing instead of placement. The free routes are EQ inside a recording app, or the tone controls some call apps and mic utilities offer. The guide to making your mic sound better without buying a new one collects them in one place. The catch is that most of them work inside one app: the EQ in your editor does nothing for your Zoom call.
On a Mac, that gap is what TunedMic is built for. It adds a virtual microphone called TunedMic that Zoom, Google Meet, Teams, Discord, Telegram, OBS and browsers can all select, and it processes your real mic before any of them hear it. Setup is a one-minute Sound Check where you read aloud and the app takes more than 30 measurements of your voice, your mic and your room. The Narrator family includes a profile called Warm, built from that Sound Check rather than a stock preset, and a 12-band equalizer is there if you want to steer the low end yourself.
A few honest limits. TunedMic does not change mic physics: on a cardioid, distance is still the first lever, and it costs nothing. It runs on Macs with Apple silicon and macOS 14 or later, with no Windows version. And because the profile is built from what Sound Check measures, run it at the distance you actually talk from, not leaning in for the reading.
Quick answers
Does a condenser mic have proximity effect? Yes, if it is directional. The effect depends on the pickup pattern, not on whether the capsule is dynamic or condenser.
Is proximity effect the same as "radio voice"? It is one ingredient. Distance supplies the low end; the rest is compression, EQ and delivery, covered in the radio voice guide.
Can I fix too much proximity effect after recording? Mostly, with a high-pass filter or a low-shelf cut. What you cannot remove afterwards is the tone moving up and down as your head moved, because that changes from sentence to sentence.
Does it work the same for every voice? No. Neumann notes the effect matters most for voices with a lot of energy below 200 Hz, usually lower voices, and less for higher ones.
Your next step
Tonight, before your next call or stream, put a ruler next to your mic and run the four-take test at 3, 6, 10 and 20 cm. Mark the winning distance on the boom arm with tape. If you find you are on a MacBook mic, AirPods or an omni clip-on and there is no distance to play with, watch the 38-second video on the home page to see how short the Sound Check is, and then try TunedMic's free seven-day trial on the mic you have, which starts at first launch and needs no card, or check pricing ($19 one-time as of November 2026).